Original fog concept. In security fog we use much smaller fog particles.
PHARMA GRADE
Our 'smoke' security fluid is controlled by batch number and made to precise pharmaceutical standards.
FDA APPROVED
Security fog is made of FDA approved ingredients. You probably had them today in your toothpaste, coffee and bread.
REAL-TIME
A microprocessor runs custom software to dynamically adjust flows in real-time, to optimize your security protection.
Cleanup? ...none
You simply can't tell there was a security fog activation
STAINS ZERO
Safe even on silk, thin, valuable paper and other sensitive materials.
FILMS ZERO
Everyone can continue working right after hours of saturated security fog, which is probably not your use-case.
SMELLS ZERO
There is no smell from the security fog process. It doesn't smell like smoke. The hard fact is nothing bad happened.
GUNS ARE SAFE
You protect serious police and military optics. No condensation inside lenses. FlashFog doesn't harm your items or internal systems.
YOU ARE SAFE
Customers spend hours every day in similar fog. You yourself have likely been exposed to similar substances in everyday products.
ELECTRONICS ARE SAFE
Security fog doesn't harm servers, plotters, controls, electronics, cameras, or any sensitive equipment. It's inherently clean.
FAQs
HOW DO I INSTALL?
Protect easily. See our Security Fog Installation guide.
HOW LONG CAN THE FOG PROTECT?
Flashfog protects for at least 30 minutes. The fog is stable up to 45 minutes.
An optional timer allows re-firing. However, note that after about two hours you will start to get tiny droplets deposited onto flat horizontal glass surfaces. Factory defaults are for a single activation, which will not cause deposition.
Any fog fluid deposition is easily wiped with a wet towel.
JUST HOW CLEAN IS IT?
In our 26 years, we have excelled in these tough cases, with flying colors:
- Tobacco: Does not change taste or smell of cigarettes, cigars, even if out of the pack. In fact tobacco and cannabis security is one of our specialties.
- Fur coats: No smells
- Nuclear reactors: We protect those too (USA), and these folks really tested the fog, then tested again. Safe.
DO YOU HAVE A SAFETY DATA SHEET?
Yes!
Here is a PDF of our Security fog fluid safety data sheet.
False alarms are not a problem.
Protect with fog for just $10
ECONOMICAL
Full security fog activations where the area is completely obscured average $10. At these prices some customers activate just to show friends!
MOST COST LESS
Most false alarms are user error. People get the alarm code right the second time. This typically takes five to ten seconds, using only $2 to $5 worth of security fog fluid.
EASY TO AVOID
FlashFogs can be wired to an independent sensor, to confirm the break-in. See the FAQ below.
FAQs
CAN I DISARM WITH A KEY FOB?
Yes, this can be setup by your alarm installer. He can also make it so that arming your regular alarm automatically arms your fog security.
If you go with the AJAX™ installation option, you simply order a compatible keyfob module and plug it into your Ajax hub.
CAN I CONFIRM IT'S A REAL BREAK-IN?
To avoid false alarms, FlashFogs can use a second signal, from an alarm sensor directly connected to the FlashFog. This means security fog only protects when both security sensors go off simultaneously. Note: In smash & grab burglary, speed is the name of the game, so we actually don't recommend this option.
We recommend following the well-developed guidelines from FARA (False alarm reduction association) to tackle the false alarm problem head-on. They have specifically looked at security fog, and know it works well within the framework of electronic alarm dispatch.
A SWEET SMELL
For easy identification, the fog smells citrusy. The smell does not linger.
EXTREMELY DRY
The fog feels just like thick air. The particles are so tiny they float around for at least 30 minutes.
SOUNDS CHANGE
Sounds are notoriously muffled, which adds to the eerie, scary feeling.
It's not a trap.
Like an airbag, FlashFog hurls a barrier in real-time. Protects before burglars even come in.
Why Not Trap Burglars?
The success of a security system is measured in dollars saved and the probability of the burglar returning. We're 8 out of 9 pack-trapping burglars has allowed crime that goes well beyond property protection and does not add to the bottom line.
How Is This Done?
FlashFog complies with the European security fog standard (CENELECEN 50131-8). Our manuals implement best practices developed with input from police and fire departments worldwide.
It's about $20 / shot.
Once security fog is gone, you simply can't tell there was an activation.





YOU WON'T RUN OUT
Fluid levels are permanently monitored and the security fogger lets you know if it's running out.
IT'S NOT A PRINTER
It's cheap to run. The fluid only needs replacing every three years, unless of course the bandits try to break-in. FlashFog only needs about 50 watts (small model).
YOU ONLY USE A FRACTION
Most users get at least four full security activations per fluid charge. Depending on sizing, you get between two and eight activations per charge.
This is how we help you
Model Selection
Site Selection
Important Details
How it's Installed
FAQ?
Please ask us your question!